How To Stabilize Iphone Camera Without Tripod

Download Article

Download Article

This wikiHow teaches you how to stabilize your iPhone when taking photos by using a plastic cap as a tripod. Information technology's a toll effective way to improve your photography.

Steps Download Article

1. i

   Discover a sturdy plastic cap. The cap needs to be able to support the weight and rigidity of your iPhone, so you should avert caps with a lot of requite that bend significantly.

   • Caps from droplets cans work well.

2. 

   2

   Cutting the cap vertically twice. Brand the cuts approximately 5mm apart down the sides of the cap.

   • Cutting well-nigh halfway downward seems to work well.
   • The width of your cutting may differ depending on the size of your phone. If your iPhone is an older model (pre-iPhone five), make your cuts closer to 10mm apart.

   Advertisement

3. 

   iii

   Rotate the cap 180 degrees. You should now be holding the cap with the cuts you lot merely fabricated on its opposite side.

4. 

   iv

   Cutting the cap again. Information technology will exist the same type of incisions you made in Footstep 2.

   • Try to keep all iv cuts equal distances apart. If one side is cut more narrowly than another, your phone may stone while sitting in the tripod or slip out of its hold.

5. 

   v

   Button the two flaps away from each other. This is done by pulling the flaps downward as far as they volition go.

   • It will create a permanent crease in the plastic.
   • Be careful not to break the flaps off of the cap - yous'll be using them to assistance stabilize your phone.

6. 

   6

   Release the flaps from your grip. Doing and then will make them render to near horizontal position which provides more stability for your phone.

   • If you want the option of being able to angle your camera to shoot up or down, repeat the steps higher up with 30 degree angled cuts.

7. seven

   Grab an empty water bottle.

8. 

   eight

   Cut a hole in the bottom of the cap. Information technology should be the same size as the mouthpiece on a plastic water bottle.

9. 

   9

   Fill the bottle with h2o.

10. 

    10

    Button the bottle mouth through the sturdy aerosol cap.

11. 

    eleven

    Secure the tripod by screwing dorsum on the water canteen cap. Doing will give your phone greater stability for photos and prevent you from spending coin on a tripod.

Advertisement

Ask a Question

200 characters left

Include your email address to become a message when this question is answered.

Submit

Advert

• By making a hole in the lesser of the cap the size of the oral cavity of a plastic drink canteen you tin can use the bottle to add height and stability to your tripod. Remove the cap from the bottle, fill with water , push the bottle oral cavity thru the tripod and secure by tightening the cap back onto the canteen

• If your phone isn't sitting perfectly horizontal, manipulate the flaps until it does

• Cheaper quality plastic caps are easier to cut than more heavy duty versions.

Thanks for submitting a tip for review!

Ad

Nigh This Article

Thanks to all authors for creating a page that has been read 78,840 times.

Is this article upward to appointment?

Source: https://www.wikihow.com/Make-an-Instant-iPhone-Tripod

Posted by: baconfitionly.blogspot.com

Share this post